Specifications; Stihl Bga 100 Blower; Noise And Vibration Data - Stihl BGA 100 Gebrauchsanleitung

English
Condition LEDs on Bat‐
tery
1 LED glows
red.
3 LEDs flash
red.
3 LEDs glow
red.
4 LEDs flash
red
Blower cuts out 3 LEDs glow
during operation red.
Blower runtime is
too short

18 Specifications

18.1

STIHL BGA 100 Blower

Approved batteries:
• STIHL AR
• STIHL AP together with "AP belt bag with
connecting cable"
– Air speed with nozzle mounted: 63 m/s
– Weight: 2.5 kg
For battery life see www.stihl.com/battery-life.
26
Cause
Battery too hot or too
cold.
There is a malfunction
in the blower.
Blower too hot.
There is a malfunction
in the battery.
No electrical contact
between blower and
battery.
Blower or battery
damp.
Blower too hot.
There is a electrical
malfunction.
Battery not fully char‐
ged.
Normal battery life
has been exceeded.
18.2
K-value for sound pressure level is 2 dB(A). K-
value for sound power level is 2 dB(A). K-value
for vibration level is 2 m/s².
STIHL recommends that you wear hearing pro‐
tection.
– Sound pressure level L
to EN 50636‑2‑100: 80 dB(A)
– Sound power level L
EN 50636-2-100: 90 dB(A)
Remedy
► Pull the connecting cable plug out of the
socket.
► Allow battery to cool down / warm up.
► Pull connecting cable plug out of the
socket and then refit it.
► Switch on the blower.
► If 3 LEDs continue to flash red: Do not
use the blower and contact your STIHL
servicing dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow blower to cool down.
► Pull connecting cable plug out of the
socket and then refit it.
► Switch on the blower.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Pull connecting cable plug out of the
socket and then refit it.
► If blower still does not start when swit‐
ched on: Clean contacts of connecting
cable as described in the STIHL AR bat‐
tery's instruction manual or in the user
instructions for the "AP belt bag with
connecting cable".
► Allow blower or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow blower to cool down.
► Pull connecting cable plug out of the
socket and then refit it.
► If blower continues to cut out during ope‐
ration: Clean contacts of connecting
cable as described in the STIHL AR bat‐
tery's instruction manual or in the user
instructions for the "AP belt bag with
connecting cable".
► Switch on the blower.
► Recharge the battery fully as described
in the instruction manual for the STIHL
AL 101, 300, 500 chargers.
► Replace the battery.

Noise and Vibration Data

pA
measured according to
wA
18 Specifications
measured according
0458-711-9821-C