Fastener Driving Tool Maintenance; Cleaning The Housing And Outer Surfaces - Prebena 3X-CNW50 Originalbetriebsanleitung

Fastener driving tool maintenance

Fastener driving tool maintenance
The fastener driving tool must only be serviced by persons
who have the necessary knowledge, abilities and experience.
All tasks not described here must only be performed by the
manufacturer's Customer Service or the manufacturer.

Disconnect the fastener driving tool from the compressed air supply
before cleaning tasks.

Empty the magazine.

Cleaning the housing and outer surfaces

PLEASE NOTE
Damage to the fastener driving tool or accessory due to unsuitable
cleaning agent.

For cleaning use only a dry, slightly moistened cloth or a cloth
moistened with a mild soap solution.
Light soiling

Wipe off the housing of the fastener driving tool with a dry cloth.

Oil all the metal parts of the fastener driving tool with a thin film
of PREBENA-special nailer oil.
Heavy soiling

Wipe off the housing of the fastener driving tool with a cloth
slightly moistened with a mild soap solution.

Next wipe off the housing with a cloth slightly moistened
with tap water.

Then rub with a soft, dry cloth.

Oil all the metal parts of the fastener driving tool with a thin film
of PREBENA-special nailer oil.
36
WARNING
Accidental triggering while emptying the magazine
may result in severe or fatal injuries.