Adjusting The Nail Length - Prebena 3X-CNW50 Originalbetriebsanleitung

Adjusting the nail length

Types 3X-CNW50, 5F-CNW65, 7F-CNW90, 8XR-CNW90 and 9F-
CNW100EPAL
Inside the magazine there are two scales graduated in centimeters
and inches. These scales show the nail length that can be selected
for the relevant fastener driving tool.

To use longer nails, pull the magazine shaft (1) out to the desired
position.

To engage the magazine disk (2) in the desired position,
turn the magazine shaft (1) clockwise as far as it will go.
The magazine disk engages.

To use shorter nails, pull the magazine shaft out a little.

Turn the magazine shaft counter clockwise.

Push the magazine shaft to the desired position.

To engage the magazine disk in the desired position,
turn the magazine shaft clockwise as far as it will go.
The magazine disk engages.
Preparation of the fastener driving tool
21