Using The Fastener Driving Tool With A Weight Compensator; Checking The Function - Prebena 3X-CNW50 Originalbetriebsanleitung

Preparation of the fastener driving tool

Using the fastener driving tool with a weight compensator

You can use fastener driving tools 5F-CNW65, 7F-CNW90, 8XR-CNW90
and 9F-CNW100EPAL with a weight compensator. To be able to mount
the cable of the weight compensator on the fastener driving tool, screw
a suspension eye into the thread on the housing head. The suspension
eye (item number ET 99300122) is available from PREBENA.

To mount the eye (1) on the housing head, remove the rubber plug
(2) from the thread.

Screw the eye (1) clockwise into the thread as far as it will go.

Checking the function

To ensure the fastener driving tool is functioning properly,
follow these steps:
PLEASE NOTE

Follow the hazard warnings in the "Safety" section starting on page 6.

Set the tip of the fastener driving tool on a piece of wood at least
ten centimeters thick.

Trigger the fastener driving tool (see section on driving in coil nails
on page 31).

Check the following properties:
-
Triggering only occurs when the triggering safety device
is pressed in.
-
One nail must be driven into the piece of wood every time
the fastener driving tool is triggered.
-
Do not allow the exhaust air to blow in your face.

To obtain the desired insertion depth, change the operating pressure
of the compressor as necessary or change the setting on the setting
wheel (see page 28).

Repeat these steps if necessary.
The fastener driving tool is now ready for use.
26