Master ECLIPSE COMPACT Bedienungsanleitung Seite 14

- Verify that the environment doesn't be disturbed by devices working at the same
frequency (for example earphones, alarms, ecc).
- Make a reset of the system (see point 9) and try again to insert the transmitter.
- The receiver of the central unit could be demage and could be necessary the
substitution of the central unit.
? When try to memorize further transmitter, the motor efects 2 movements
downward
- Check that the transmitters memorized yet working correctly.
- Be sure to have correctly execute the procedure of memorization (point 8.1).
- The procedure of memorization was execute too much slowly. At moment that
the central entries in "transmitter programmation" there are 8 sec to press the
button STOP of the transmitter to memorize.
- Check that the batteries of transmitter to memorize are loaded.
? When try to memorize a transmitter, the motor does 1 upward movement
and 3 downward movements.
- The central unit signals that it has memorized yet the top numbers of 15 trans-
mitters, the memorization of further transmitters is not allowed.
? When try to cancel a transmitter from the memory, the motor does 2 down-
ward movements.
- Be sure to have correctly execute the procedure of cancellation (point 8.2).
- The operation was execute too much slowly. At moment that the central unit
entries in " transmitter programmation" there are 8 sec to press the button STOP
of the transmitter to cancel.
- If the central unit has only one transmitter in its memory, this operation is forbid-
den.
? In presence of wind it doesn't ordered the upward.
- The wind threshold could be too much high (point 8.3). Let down the wind
threshold.
- The central unit could be installed in position a little exposed to the wind.
- The wind sensor could be demage. Verify the working (rotate the blades to sim-
ular the presence of wind and verify that the central unit entries in "wind alarm").
? In presence of wind it's ordered an upward, but in presence of sun doesn't
ordered the downward.
- The sun threshold could be too mach high (see point 8.4). Let down the sun
threshold.
- The central could be installed in position little expose to the sun, or some obsta-
cles could prevent the correct sun survey.
- The sun function could be desactivate (see point 7.2). Activate the sun function.
- The sun sensor could be demage. Verify the working (if the sun function is active
and the yellow led is switch off, apply a light on the little dome of the sensor, the
yellow led has to flash speedly).
- All the products and the specific techicals contained in this document are subjected to varia-
tions without any warning.
- Only in case of concessions and specific case preaviusly agreement with the head office the
device has to be used only with received device from the same head office.
The manufacturer can not be considerated responsable for eventual damage caused by inap-
propriate, wrong or unreasonable use.
- MASTER declares that the device is accordance with the principal requirement and
the other arrangement provided by directive 1999/5/CE. The declaration of conform-
ity is available by this site http://www.masterautomation.it/certificazioni/pagine.
14 ECLIPSE COMPACT_rev00