Side-Discharging The Clippings - Toro Recycler 20961 Bedienungsanleitung

Removing the Grass Bag
To remove the bag, reverse the steps in
Grass Bag (page 12).
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 18).
Figure 18
1. Bag-on-demand lever (in the bagging position)
•
To recycle or side-discharge the grass and
leaf clippings, press the button on the lever and
move the lever rearward until the button on the
lever pops up.
Important:
For proper operation, shut off
the engine, wait for all moving parts to stop,
and then remove any grass clippings and
debris from the bag-on-demand door and the
surrounding opening
move the bag-on-demand lever from 1 position
to another.
Installing the
(Figure 19) before you
1. Clean here
Side-Discharging the
Clippings
Use side-discharging for cutting very tall grass.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position, move
the lever to the recycling position; refer to
the Bag-on-Demand Lever (page
g198723
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute
13
Figure 19
Operating
13).
(Figure 20).
Figure 20
g198734
g235646