Operating Elements And Connections - EuroLite FD-512 Bedienungsanleitung

4. OPERATING ELEMENTS AND CONNECTIONS

6
1 Display
2 Channel faders 1 to 8
For adjusting the brightness of the connected
light effect units between 0 and 255. The
current DMX value is indicated in the display.
3 Buttons PAGE UP and PAGE DOWN
• For selecting 8 control channels each for
channel faders.
• For adjusting the flash duration (0.1sec-10
min) together with the button FLASH.
• Press both buttons simultaneously to set all
control channels to the value zero.
4 Button FLASH with control LED
• Short actuation: Sets all control channels to
the maximum value 255—regardless of the
channel faders (LED flashes).
By pressing the button once again, the unit
returns to the previous channel values.
• Long actuation: Switches the setting mode for
the flash duration on and off.
2
7
5
6
7
8
13/16
1
8
Button BLACK OUT with control LED
• Short actuation: Sets all control channels to
the value zero—regardless of the channel
faders (LED lights). By pressing the button
once again, the unit returns to the previous
channel values.
• Long actuation: For storing the current scene
into the internal memory. This scene is
automatically sent to the output each time the
unit is switched on and may be used for a
suitable basic illumination.
Power on/off
Switches the controller on and off.
Power input
Plug in the mains cable of the supplied power
unit here.
DMX512 outputs
Zum Anschluss an den DMX-Eingang des
ersten Lichteffektgeräts; je nach Bedarf kann
entweder die 3-polige oder die 5-polige XLR-
Buchse verwendet werden.
00081147.DOCX, Version 1.0
3
4
5