Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. SETUP
Switch off the DMX controller prior to connecting any units or to changing any existing connections.
Installation
Install the unit on a plane surface or in your rack with the optional mounting frame. When choosing the
installation spot make sure that there is enough space around the unit for ventilation or that heated air from
the rack can be passed on to improve heat radiation. Steady overheating will damage the unit.
DMX512 Connection
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable in order to connect the controller with the fixture or one fixture with another.
Occupation of the XLR connection:
1
Connect the DMX output of the FD-512 to the DMX input of the first light effect unit. Depending on the
jack of the fixture, use the 3-pole or the 5-pole XLR jack DMX OUT.
2
Connect the DMX output of the first fixture in the DMX chain to the DMX input of the next fixture. Always
connect one output to the input of the next fixture until all fixtures are connected.
3
At the last fixture, the DMX cable has to be terminated with a terminator. For this solder a 120
resistor between Signal (–) and Signal (+) into a 3-pin XLR plug and plug it in the DMX output of the last
fixture.
Connection to the Mains
Connect the power supply unit to the power input jack and the mains plug to a mains outlet. Always
disconnect the mains connector when you wish to change connections, move the unit to a different place or
if it is not used for a longer period.
the fixtures will not work at all, or will not work properly.
14/16
00081147.DOCX, Version 1.0
Ω
Werbung
Inhaltsverzeichnis
