BWT AQA drink Pro 20 CAS Einbau- Und Bedienungsanleitung Seite 18

Water is not dispensed
Not enough water is dispensed
Cold water cannot be dispensed
Cannot dispense CO
2
Cold water not cold enough
Water contains too little CO
2
When the CO button is pressed, only
2
CO escapes
2
34
Not enough water
pressure in the water Increase the water pressure
supply
Filter cartridge is
Insert new filter
blocked
Problem with the pres-
sure regulation or the Contact a service technician
pump in the device
Not connected to the Connect the device to the power
power supply supply
Filter cartridge is
Insert new filter
blocked
Incoming water pres- Check and, if necessary, increase
sure too low incoming water pressure
On/off switch for cool- Switch on the on/off switch for the
ing (COLD) is off cooler (COLD) on the rear panel
No coolant available Contact a service technician
Problem with the
thermostat or com- Contact a service technician
pressor
Check the water supply. If this is in
No water in the cold
working order, inspect the water
water supply
pipework in the device
Disconnect the device from the
Ice formation in the power supply, allow the ice to melt,
cold water tank reconnect the device to the power
supply or switch it off
Not enough water in the Top up the water or refill the tank and
tank check the device's pipework
Defective pump Contact a service technician
CO on/off switch
2
on the rear panel is Switch the CO on/off switch to on
2
switched off
Thermostat is not set Check the thermostat and, if neces-
correctly sary, reduce the temperature
CO gas cylinder is
2
Replace the CO gas cylinder
2
empty
Turn off the water and actuate the
CO tank must be CO outlet until only gas escapes.
2 2
vented Then turn on the water again and
allow the CO to refill
2
Insufficient CO pres-
2
Increase CO pressure up to 4 bar
2
sure
Set the thermostat to a lower temper-
Temperature setting is
ature. The higher the water tempera-
too high
ture, the less CO can be absorbed
2
Disconnect the device from the pow-
Pump does not react er supply for 30 seconds and recon-
nect and press the CO
2
Flashing light at the water outlet
Water leakage
UV LED indicator flashes on the control
panel, an acoustic alarm sounds and
water cannot be dispensed
key again
Wastewater tank is full Empty the wastewater tank
Leakage sensor is
Contact a service technician
activated
Close the water tap, disconnect the
Water pipes in the
device from the power supply, then
device are defective
contact a service technician
Disconnect the device from the
power supply and unplug the connec-
tion; plug it back in, then switch the
UV lamp is not con- device on again. If the UV lamp does
nected properly or is not work, then disconnect the device
defective from the power supply again and
replace the UV lamp. It is essential to
observe the warnings, see Section
6.4.
35