End Of Operations - GGP ITALY SPA 28 Mono Gebrauchsanweisung

Inhaltsverzeichnis

Verfügbare Sprachen

b) 4-point blade (Fig. 12)

Proceed using the machine as a traditional

scythe, with a circular movement of about 60-

90°, thus moving outside the undergrowth, and

so on.

c) Cutting line head

WARNING!

Use ONLY nylon lines. The

use of metal lines, plasticised metal lines

and/or lines not suitable for the head can

cause serious injuries and wounds.

During use it is advisable to stop the engine peri-

odically and remove the weeds wound round the

machine, so as to prevent the drive tube from

overheating due to the grass caught under the

guard.

Remove the caught-up grass with a screwdriver

to allow the rod to be properly cooled.

WARNING!

Do not use the machine

for sweeping, tilting the cutting line head.

The power of the engine could throw objects

and small stones 15 metres or more, causing

damage and injuries to people.

• Cutting in motion (Scything) (Fig. 13)

Proceed at a regular pace, with a circular motion

similar to a traditional scythe, without tilting the

cutting line head during the operation.

First try cutting at the right height in a small area,

so as to then achieve a uniform cutting height

keeping the cutting line head at a constant dis-

tance from the ground.

For heavier cutting it can be useful to tilt the cut-

ting line head by about 30°.

WARNING!

Do not work in this way if

there is the possibility of causing objects to

be thrown, which could harm people and ani-

mals and cause damage.

• Precision cutting (Trimming)

Keep the machine slightly tilted so that the lower

All manuals and user guides at all-guides.com

part of the cutting line head does not touch the

ground and the cutting line is at the required

point, always keeping the cutting device at a dis-

tance from the operator.

• Cutting near fences/foundations (Fig.14)

Slowly approach the cutting line head to fences,

posts, rocks, walls, etc. without hitting them

hard.

If the line strikes a solid object it could break or

become worn; if it gets tangled in a fence it

could break abruptly.

In any case, cutting around pavements, founda-

tions, walls, etc. can cause greater wear than

normal in the line.

• Cutting round trees (Fig.15)

Walk round the tree from left to right, approach-

ing the trunks slowly so as not to strike the tree

with the line and keeping the cutting line head

tilted forward slightly.

Remember that the nylon line could lop or dam-

age small shrubs and that the impact of the

nylon line against the trunk of bushes or trees

with soft bark could seriously damage the plant.

• Adjusting line length when working (Fig. 16)

This machine is fitted with a "Tap & Go" head.

To release more line, tap the cutting line head

against the round with the engine at top speed:

the line will be released automatically and the

knife cut off the excess length.