Ec Declaration Of Conformity; Instruction Manual; General Power Tool Safety Warnings - Makita GA7010C Bedienungsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model
Depressed center wheel diameter
Max. wheel thickness
Spindle thread
Rated speed (n) / No load speed (n
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change with-
out notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Model GA7010C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model GA9010C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Model GA7010C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model GA9010C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
)
0
) : 90 dB (A)
pA
) : 101 dB (A)
WA
) : 91 dB (A)
pA
) : 102 dB (A)
WA
2
) : 9.5 m/s
h,AG
2
2
) : 2.5 m/s
h,DS
2
2
) : 6.0 m/s
h,AG
2
2
) : 2.5 m/s
h,DS
2
GA7010C
180 mm
M14
-1
8,400 min
453 mm
4.3 kg
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
NOTE: The declared vibration emission value is used
for main applications of the power tool. However if the
power tool is used for other applications, the vibration
emission value may be different.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.

General Power Tool Safety Warnings

WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for
future reference.
5 ENGLISH
GA9010C
230 mm
6.5 mm
M14
-1
6,000 min
453 mm
4.5 kg
/II