Finding New Stations-Dab; Manual Tuning-Dab; Dynamic Range Control (Drc)-Dab - PERFECTPRO ROCKHART Bedienungsanleitung

a.
Displays text messages such as the
Text
artist or track name, phone in number,
traffic alerts, etc.
b.
Signal Displays the strength for the station
being listened to. The signal strength
strength
graph can be used when positioning the
radio or its antenna. For good reception
the graph should occupy three or more
blocks.
c.
Displays the type of station being
Program
listened to such as Pop, Classic, News
Type
etc.
d.
Displays the name of the DAB multiplex
Multiplex
to which the current station belongs.
Name
e.
Frequency Displays frequency and channel number
for the currently tuned DAB station.
& channel
f.
Bit rate Displays the digital bit rate and audio
coding information for the station being
and audio
listened to.
type
g.
Time Displays the current Time.
h.
Displays the current date.
Date

Finding new stations-DAB

From time to time, new DAB radio stations may become
available. Or you may have moved to a different part of
the country. In this case you may need to cause your
radio to scan for new stations.
1.
Press and hold the Menu button until the Advanced
DAB menu shows on the display.
2.
Rotate the Tuning control until 'Full scan' is shown on
the display.
3.
Press the Tuning control to initiate the scan. The
display will show 'Scanning' and your radio will perform
a scan of the DAB Band III frequencies. As new
stations are found the station counter will increase
and stations will be added to the list. The bar graph
indicates the progress of the scan.
4.
Alternatively press Auto tune button to scan for new
stations.

Manual tuning-DAB

Manual tuning allows you to tune your radio to a particular
DAB frequency in Band III. Any new stations found will be
added to the station list. This function can also be used
to assist the positioning of the antenna or the radio to
optimize reception for a specific channel or frequency.
1.
Press and hold the Menu button until the Advanced
DAB menu shows on the display.
2.
Rotate the Tuning control until the display shows
'Manual tune'.
3.
Press the Tuning control to enter the manual tuning
mode.
4.
Rotate the Tuning control to select the desired DAB
channel. Then press the Tuning control to confirm the
selection. The open block in the signal strength graph
shows the minimum signal strength needed for good
DAB reception. The signal blocks will go up and down
showing the changing signal strength as you adjust the
antenna or the radio position. Any new radio stations
found on the tuned DAB multiplex will be added to the
list stored in the radio.
5.
Press the Tuning control to return to normal tuning mode.

Dynamic Range Control (DRC)-DAB

The DRC facility can make quieter sounds easier to hear
when your radio is used in a noisy environment.
There are three levels of compression:
DRC off No compression applied.
DRC high Maximum compression applied.
DRC low Medium compression applied.
1.
Press the Standby button to switch on your radio.
2.
Press the Source button until the DAB band is selected.
3.
Press and hold the Menu button until the Advanced
DAB menu shows on the display.
4.
Rotate the Tuning control until 'DRC' appears on the
display. Press and release the Tuning control to enter
the setting. The display will show the current DRC
value which will be marked with an asterisk.
5.
Rotate the Tuning control to select the required DRC
setting.
6.
Press the Tuning control to confirm the setting. After
several seconds the display will return to the normal
radio display.
NOTE
Not all DAB broadcasts are able to use the DRC
function. If the broadcast does not support DRC, then
the DRC setting in the radio will have no effect.
Station order setup
Your radio has 2 station order settings from which you can
choose. The station order settings are, alphanumeric and
ensemble.
1.
Press the Standby button to switch on your radio.
2.
Press the Source button as needed to select DAB radio
mode.
3.
Press and hold the Menu button to enter the Advanced
DAB menu shows on the display.
4.
Rotate the Tuning control until 'Station order' is shown
on the display.
5.
Press the Tuning control to enter the station order
adjustment mode.
6.
Rotate the Tuning control to choose between
'Alphanumeric' and 'Ensemble'.
'Alphanumeric'-sorts the station list alpha-numerically
0...9 A...Z.
'Ensemble'-organizes the station list by DAB multiplex.
The current setting is indicated by an asterisk.
7.
Press the Tuning control to select the required station
order.
GB
NL
D
F
5