IKEA TVÄTTTAD Bedienungsanleitung Seite 14

ENGLISH
Problem
The appliance does not
fill with water properly.
The appliance does not
drain the water.
The appliance door is
open or not closed cor‐
rectly.
Internal fail. No com‐
munication between
electronic elements of
the appliance.
The mains supply is
unstable.
We recommend the use of original spare
parts. After the check, switch on the
appliance and press the button
the programme.
If the problem remains, contact your
Authorised Service Centre. The necessary
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or bends.
• Make sure that the connection of the water inlet hose is correct.
• Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to "Care and cleaning".
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without drain
phase.
• Set the drain programme if you set an option which ends with
water in the tub.
• Make sure that the door is properly closed.
• The programme was not finished properly or the appliance
stopped too early. Switch the appliance off and on again.
• If the alarm code appears again, contact the Authorised Service
Centre.
• Wait until mains supply is stable.
to restart
To download the full version visit www.ikea.com
data for the service centre is on the rating
plate. Refer to 'Inspection check list' chapter.
In case of failures not linked to a warning
code, please refer to the complete version of
the user manual available in the web
14