tell Compact GSM II Schnell-Installationsanweisung Seite 9

Compact GSM II Quick guide
Configuring the temperature sensor
1. Connect the temperature sensor to input IN1 as shown in the wiring diagram.
2. Enable the temperature sensor in the Inputs section.
3. Configure the desired low and high temperature thresholds in the
Temperature section. When the temperature thresholds are reached,
temperature events are generated about which the device can send
notifications as configured in the event settings.
You can also request status information in SMS, which also includes the value
of the actual temperature measured. For this, send the INFO?# message to the
phone number of the SIM card installed in the device.
When using a temperature sensor, the Normally open input mode can still be
used at the same time with input IN1 to send notifications upon triggering the
input, but taking into account that the device is unable to receive temperature
data from the sensor while the input is shorted (in an activated state). Therefore,
you can use these two functions together only with short alarm trigger signals.
When a temperature sensor is used, the Normally closed and the Car alarm
adaptation operating modes cannot be used on input IN1, otherwise
temperature sensing will not work.
9