Wi Ring; Information At The Ets-Software; Starting Up - Mean Well KNX-40E-1280D Bedienungsanleitung

1. 6 Wi ring
•
Use wires with an adequate cross-section
•
Use suitable mounting tools to do the wiring and mounting
•
The maximum number of
•
The maximum length of a line segment is 350 m, measured along t
•
The maximum distance between two bus devices cannot exceed 700 m
•
The maximum length of a bus
Type
Solid wire
Stranded wire
American wire gauge
Wire stripping length
Screwdriver
Recommended tightening torque

1.7 Information at the ETS-Software

Selection at the product database:
Manufacturer: MEANWELL Enterprises
Co.Ltd. Product family: System Devices
Product type: Power Supply Unit
Product name: addicted to the used type, e.g.: KNX-40E-1280D, Power Supply (230V/1280mA)
Order number: addicted to the used type, e.g.: KNX-40E-1280D

1.8 Starting up

After wiring, the allocation of the physical address and the parameterization of every channel follow:
(1)Connect the interface with the bus, e.g. MEANWELL USB interface KSI-01U.
(2)Switching the power supply.
(3)Set bus power up.
Press the programming button at the device (red programming LED lights).
(4)
Loading of the physical address out of the ETS-Software by using the interface (red LED goes out, as well this process was
(5)
completed successful).
Loading of the application, with requested parameterization.
(6)
If the device is enabled you can test the requested functions (also possible by using the ETS-Software).
(7)
bus evices connected is d 256
line is 1000 m, keeping into account all segments
AC and ancillary
(L, N, , +V, -V)
0 .5 ~ 4. 0mm
2
0.5 ~ 2 mm .5
12 ~ 26AWG
6 5mm . (0.255")
3mm Slotted
8 kgf-cm (7 lb in - )
he line between the power supply
power terminals
and the furthest bus device
KNX bus terminal
( BUS +V, BUS V) -
0.6 ~ 0.8Φ
------
20 ~ 22AWG
5mm (0.196")
-----
-----
3