Mean Well KNX-40E-1280D Bedienungsanleitung Seite 17

ETS ‐text
Bus Restart Times Count
Restart Times Cyclic
Sending
Startup Times Count Read
Startup Times Cyclic
Sending
Total Working Time Read
Total Working Time
Difference Sending
Operating Time Duration
Operating Time
Difference Sending
The following chart shows the objects that belong to general setting:
Number Name
7 Total working time
8 Time from last start up
The number of bus restart
9
times
10 The number of devices
startup times
Dynamic range
[default value]
Disable
Enable
OFF, 1min, 2min, 3min, 4min, 5min,
10min, 15min, 20min, 25min, 30min,
1hour, 2hours, 3hours, 4hours, 5hours,
6hours, 7hours, 8hours
[OFF]
Disable
Enable
OFF, 1min, 2min, 3min, 4min, 5min,
10min, 15min, 20min, 25min, 30min,
1hour, 2hours, 3hours, 4hours, 5hours,
6hours, 7hours, 8hours
[OFF]
Disable
Enable
0 - 28,000,000
[0]
Disable
Enable
0 - 28,000,000
[0]
Length
4bytes
4bytes
2bytes
2bytes
Comment
Enable or disable Bus restart times count.
Send the latest value at intervals you desired
Enable or disable Startup times count read-out
Send the latest value at intervals you desired
Enable or disable total working time read-out
Difference between actual and last sent value which
triggers the sending
Enable or disable operating time duration
Difference between actual and last sent value which
triggers the sending
Usage
The device sends the time counted value of the total
working time in s. Note: No matter Startup Times Count
Read is enabled or not, this value is saved
and cannot be cleared.
The device sends the time counted value of the time
elapsed since last device startup in s.
The device sends the number counted value of KNX
bus restarts.
The device sends the number counted value of device
startups. Note: No matter Startup Times Count Read is
enabled or not, this value is saved automatically and
cannot be cleared.
automatically
14