Busload - Mean Well KNX-40E-1280D Bedienungsanleitung

The following chart shows the objects that belong to general setting:
Number Name
Maximum output current
17
during tracking period
Maximum device temperature
18
during tracking period

3.4 Busload

The Busload measurement is to monitor load conditions. If the output exceeds the threshold you set, an alarm telegram is sent.
ETS ‐text
BusLoad Measurement
Busload Difference Sending
Busload Cyclic Sending
BusLoad Alarm
Busload Alarm Threshold
Busload Alarm Hysteresis
Behaviour On BusLoad
Alarm Active
Behaviour On BusLoad
Alarm Deactive
Length
2bytes
4bytes
2bytes
Dynamic range
[default value]
Disable
Enable
1 - 100%
[10%]
OFF, 1min, 2min, 3min, 4min, 5min,
10min, 15min, 20min, 25min, 30min,
1hour, 2hours, 3hours, 4hours, 5hours,
6hours, 7hours, 8hours
[OFF]
Disable
Enable
1 - 100%
[80%]
1 - 70%
[10%]
Nothing to do
Send 0
Send 1
Nothing to do
Send 0
Send 1
Usage
The device sends the measured output current value in
A or mA at the end of each period.
The device sends the measured device temperature
value in °C at the end of each period.
Comment
Enable or disable Busload measurement
Difference between actual and last sent value which
triggers the sending
Send the latest busload value at intervals you desired
Enable or disable Busload alram
Select a threshold value to perform the
On BusLoad Alarm
Select a hysteresis value to perform the
On BusLoad Alarm
Select a reaction when busload is higher than the
Threshold
Select a reaction when busload is lower than a value of
"Busload Alarm Threshold" - "Busload Alarm Hysteresis",
e.g. 80% - 10% = 70%
"Behaviour
Active"
"Behaviour
Deactive"
11