Counters - Mean Well KNX-40E-1280D Bedienungsanleitung

ETS ‐text
Overload Duration
Difference Sending
Short Circuits Count
Function
Short Circuits Count
Difference Sending
Short Circuits Count Cyclic
Sending
Time Load Detached
Duration Record
The following chart shows the objects that belong to general setting:
Number Name
The number of overload
21
times
Overload duration
22
The number of short circuits
23
times
24 Time load detached

3.6 Counters

There are The Number of KNX Bus Restart Times , The Number of Devices Startup Time , The Total Working Time and "
"Operating Time from Last Startup in the counters menu. Please refer to tables below for detailed information.
Dynamic range
[default value]
0-36,000
[0]
Disable
Enable
0-500
[0]
OFF, 1min, 2min, 3min, 4min, 5min,
10min, 15min, 20min, 25min, 30min,
1hour, 2hours, 3hours, 4hours, 5hours,
6hours, 7hours, 8hours
[OFF]
Disable
Enable
Length
2bytes
4bytes
2bytes
4bytes
" "
"
Comment
Telegram is sent when there is a duration difference
between current counting and the previous value sent.
This duration difference can be a range of 0 - 36000 sec,
0 = OFF. The counter starts counting when the device
is in an overload condition.
Enable or disable Short circuits count function
Telegram is sent when there is a count difference between
current counting and the previous value sent.This count
difference can be a range of 0 - 500, 0 = OFF. The counter
counts once when there is short circuit at output.
Send the latest short circuits count value at intervals
you desired
Enable or disable Time load detached duration record.
This function is used to count how long the loads are
detached in conditions, such as device startup, KNX
bus reset or short circuit.
Usage
The device sends the number counted value of overload
at regular intervals.
The device sends the total duration time in overload in
second
The device sends the number counted value of short
circuit at regular intervals.
On activation the device sends the time counter value
of load detachments
" " "
13