Mounting The Rear Wheels; Unfolding The Wheelchair; Mounting Or Removing Of Push Bar - Vermeiren V100 XL Gebrauchsanweisung

2.2

Mounting the rear wheels

2.3

Unfolding the wheelchair

CAUTION:
Risk of clamping – Keep fingers away from moving parts of the
   
wheelchair.
1. Position yourself behind the wheelchair.
2. Use the hand-grips to open the wheelchair as much as possible.
3. Position yourself at the front of the wheelchair.
4. Push both seating tubes down till they are fixed in their position.
5. Mount the push bar to the right hand-grip (standing behind the wheelchair)
2.4

Mounting or removing of push bar

1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button.
4. Check that the wheels is secured.
The mounting of the push bar is done as follows:
1. Mount the push bar with the starknob in the
left hand-grip.
2. Swing the push bar to the right.
3. Mount clip c over the right hand-grip d.
When this is difficult it is possible the push
bar is too long. Place the push bar on the
left-hand-grip with the starknop in hole d.
To take off the Push bar:
1. Loosen the starknob on the right hand-grip.
2. Remove clip c from the right hand-grip d.
ƒ‰‡
V100 XL
2012-02
.
c