Inhaltsverzeichnis
Werbung
CARE INSTRUCTIONS
EN:
The following cleaning and disinfection instructions should help you to keep your Brunner furniture looking its best and
functioning properly for as long as possible. These are recommendations only. Brunner GmbH will not be held liable for
damage to the finish caused by improper cleaning or disinfection.
General information
When using cleaning and disinfection agents, we recommend referring to the manufacturer's instructions for use and always
test the suitability of the cleaning agent on a concealed area first to avoid discolouration or abrasion.
Table top, powder-coated
Cleaning
Cleaning should be carried out with a soft, non-abrasive cloth or industrial cotton wool and pure water, with small additions
of cleaning agents that are as neutral as possible (pH value 5–8) if necessary. Allow to work briefly and carefully wipe dry
with a soft, clean cloth. Avoid rubbing too hard, as this can cause differences in finish to occur. Greasy, oily or sooty subs-
tances can be removed with aromatics-free white spirit or isopropyl alcohol (IPA). Residues of adhesives, silicone rubber or
adhesive tapes can also be removed in this way.
Please note:
· Do not use solvents containing esters, ketones, aromatics, glycol ethers, halogenated hydrocarbons or similar.
· Do not use abrasive or scouring agents.
· Do not use strongly acidic or alkaline cleaning agents.
· Do not use cleaning agents of unknown composition.
· The temperature of the cleaning agents must not exceed 25°C.
· Do not leave the cleaning agents used to work for longer than one hour. If necessary, the cleaning process can be
repeated after at least 24 hours.
Disinfection
Carry out a spray-and-wipe disinfection. Leave the disinfectant to work for a short while and then rub dry with a soft cloth.
Please avoid spot application of the disinfectant to exclude changes and discolouration of the surfaces.
Recommended products are:
· O³ SOLUTION disinfection
· Pack zu 9 rapid disinfection
· GLOBALOCID® 200
Steel panel, powder-coated
Cleaning
For normal use, it is sufficient to wipe the surface dry with a soft, dry or damp cloth. Any particularly dirty areas can be
cleaned with a standard, grease-dissolving all-purpose cleaner. Please only use soft cotton cloths for cleaning purposes and
never use plastic sponges, wire wool or steam jet devices, which could permanently damage the surface. Never use abrasive
cleaning agents or toilet or sanitary cleaners.
Disinfection
Use low-ethanol disinfectants as part of spray-and-wipe disinfection. Leave the disinfectant to work for a short while
(up to 10 minutes) and then rub dry with a soft cloth. Please avoid spot application of the disinfectant to exclude changes
and discolouration of the surfaces.
Pflegehinweise . Care Instrucctions
12 . 13
Werbung
Inhaltsverzeichnis
