Safety Label Location; Component & Control Locations; Pre-Operation Checks; Operation - Honda GXE2.0H Bedienungsanleitung

SAFETY LABEL LOCATION

See figure 1 on page II.
Safety labels are affixed to the DC Power Unit for your
instruction.
Carefully read these safety labels and the safety precautions in
this manual.
If the labels affixed to the product become unreadable, such as
if they are torn, or lost, replace them with new labels.
Contact your Honda dealer to purchase a replacement.
COMPONENT & CONTROL LOCATIONS
See figure 2 on page III and figure 3 on page IV.

PRE-OPERATION CHECKS

Check the following points before you operate the DC Power
Unit. Before beginning your pre-operation checks, be sure the
DC Power Unit is on a level surface and stopped.
Also, perform a test run during the checks.
Failure to properly maintain the DC Power Unit,
or failing to correct a problem before operation,
could result in a significant malfunction.
Some malfunctions can cause serious injuries or
death.
Always perform a pre-operation inspection
before each operation and correct any
problems.
• Before attaching the Battery Pack, make sure that:
– Exterior cover is not damaged.
– Switches are not damaged.
– Rubber support is not damaged.
– Battery hook is not loose or damaged.
– Battery fastener is not damaged.
– Battery connector is not damaged.
– Motor wire harness is not damaged. (For GXE2.0S only)
– There are no debris or excessive dirt on the DC Power Unit
or the Battery Pack.
• During the test run
– Check that all switches work (start and stop) properly
– Check that all indicators light when the DC Power Unit is
turned on
2

OPERATION

CHARGING THE BATTERY PACK

Refer to the Battery Charger manual for instructions to charge
the Battery Pack.

ATTACHING THE BATTERY PACK

Make sure to use a genuine Battery Pack.
See figure 4 on page V and figure 5 on page VI.
1. Make sure there are no debris or dirt on the battery tray.
2. Tilt the Battery Pack and insert its claw into the battery
hook.
3. Push down the Battery Pack and hook the battery fastener
to it.
4. Push the battery fastener lever up and lock the Battery Pack.
Be careful not to catch your fingers.
5. Remove the battery connector cap from the power cable.
Connect the power cable to the battery connector of the
Battery Pack.
After attaching the Battery Pack, make sure the battery hook
and fastener are securely attached.