Product Care And Storage - Lupine Betty TL2 Pro Bedienungsanleitung

Accessoires
1/4 Inch Adapter:
The adapter allows to mount the light on a tripod.
Use the screws which came with the adapter to connect it to the
light. According to the long batterytank, we recommand a stable
tripod.
Filtercap:
The special cap comes with an additional thread.
Thanks to the cap 55 mm filters, such as available
as foto accessories can be used.
3 0
Diffusor for camera:
Art. No. 892 Diffusor
Note: Filters are not supplied with the light.

Product care and storage

Cleaning:
Only clean the lamp when it is fully assembled. If required, use warm water and add some
mild dishwashing detergent.
Transport:
Caution! Always separate the battery from the lamp!
Otherwise, the small amount of power used by the electronics will discharge the battery.
Furthermore, the lamp may be switched on accidentally. The uncontrolled heat buildup
could cause a fire or melt adjacent plastic material.
Storage:
When the lamp will not be used for a longer period of time, fully charge the battery and
leave it connected to the charger. Choose a cool, dry place for storage (basement etc.).
Opening the lamp housing:
Note! The lamp housing may be opened for installing an upgrade kit or a lens.
Open the lamp housing's front screw-on cover. Hold the rear of the lamp with one hand
while rotating the front cover to the left (counterclockwise) with the other hand.
Once you have removed the cover, you will see the 7-array lens.
Please avoid touching the lenses directly.
Closing the lamp housing:
Check to ensure that the o-ring on the rear of the housing is correctly positioned. The
housing will only be waterproof if its o-ring is intact. After completing this check, carefully
screw down the housing cover. Important! The thread must always run smoothly, other-
wise, screw off the cover again immediately and try again. The fine thread will not excuse
any mishandling - therefore, be extremely careful! Fully screw down the cover.
31