Battery Warning - Lupine Betty TL2 Pro Bedienungsanleitung

Operation

Battery warning:

The LEDs on the back of the lamp-head change color to indicate decreasing voltage. When
battery voltage drops below a certain level, the Backlight LED changes from blue to green.
Near the end of the battery's charge, the light turns red.
Safety advisory: When the battery is completely discharged
( all 5 red LEDs blink with a red backlight on), the light will shut
down after flashing a few times.
In such a case, you should be careful.
Note: When permanently operating the lamp at high power, the battery
warnings may be issued in very quick sequence.
Battery full or partly low capacity
discharged remaining
2 4
very low capacity red + red blinking:
remaining battery empty
Reserve power:
When the battery is completely discharged (all 5 red LEDs
blink with a red backlight on), the light will shut down after
flashing a few times. To activate the battery's reserve power,
doubleclick the switch. This will give you a few minutes
more light, whose exact amount depends on the age of your
battery. The light emitted in reserve-power mode is a very low
beam so as to conserve power and keep the light going as
long as possible. The red 5 LEDs slowly flash when reservepo-
wer mode is activated and the backlight will be red. When the
reserve power has been completely discharged, the light will
shut down – so be careful.
Note: When operating the lamp only with 2 W or less, no reserve power will
be available.
Warning: Do not switch on the light when the battery is
discharged, as this will invariably damage the battery.
Recharge the battery as soon as possible to avoid a deep
discharged battery.
Reserve power
25