Lupine Betty TL2 Pro Bedienungsanleitung Seite 14

Customizing the brightness levels
You have the option to setup up to 4 brightness levels, in any sequence.
1.
Press and hold the button until one green
release the button

2.
The range of brightness levels you can select will begin automatically to cycle, as shown below.
3.
Press the button at the brightness level you want.
the first power-on click is presented

4.
Upon releasing the button, the sequence of
brightness levels automatically restarts, al-
lowing you to set a second level in the same
manner as the first click set-up. This process
can be repeated up to four times, but will
stop when you quit making further selec-
tions, thus allowing your light to operate in
1-step, 2-step, 3-step,-or 4-step modes.
* If in use, shown by green LED
** Will not be signalised by a status LED
2 6
LED lights up.
0.3 W
brightness lvl
2 W
brightness lvl
3 W
brightness lvl
8 W
brightness lvl
12 W
brightness lvl
16 W
brightness lvl
22 W
brightness lvl
28 W
brightness lvl
34 W
brightness lvl
45 W
brightness lvl
center (0.8W)*
SOS**
flash**
dbl click
stealth
Default setting
Center:
This setting activates the center LED to produce a low red light. The outer 6 LEDs will be disabled.
SOS:
The light will continue with SOS until the battery is empty. Use it carefully and only in case of a real
emergency. Due to the lamp's high light output, this signal is visible for several miles; the opera-
ting time is several hours. Misuse may be prosecuted!
Flash:
This mode is extremely irritating and may by no means be misused.
Double click:
If this function is activated, the lamp may only be switched on with a quick double click.
Useful for anybody who wants to avoid that the lamp is switched on accidentally in
particular during transport (e. g. in a backpack).
Stealth:
In stealth mode, initialization, voltage display, and battery warning usually indicated by the button's
LEDs are partly deactivated. Of course "stealth on" does not mean that our Betty TL Pro will no longer
give light or will even become invisible, however, LED indications will be reduced to a minimum.
Police-Mode (Special-Mode):
In the Police-Mode, the lamp only lights up, while the button is kept pressed. The lamp stops shining
at once, when you get off the button. To prevent an activation by mistake, this mode is chosen in a
special way. Press the button 8 times quickly during 2.5 – 3 seconds. To change back to the standard
mode, press the button again 8 times quickly.
27