Lupine Betty TL2 Pro Bedienungsanleitung Seite 11

Charging and Mounting
Docking Station
The flashlight can be charged in many different ways:
- By the included 12V adapter
- 12V cable and cigarette lighter socket
- Through the internal socket and a Lupine standard charger (not included)
- Direct connection to 12V - 24V DC through the included cable
Installation to the wall or inside the vehicle
To attach the docking station, use the holes in the anodized metal rail. We recommend the use of four flat
head screws, which should be selected according to the ground. Ensure a solid foundation. It takes some
force to remove the lamp from the docking station.
Hint: We recommend you to setup the connection from an experienced vehicle builder or electrician. It is advisa-
ble to design the system in a way it is only charging when the ignition is switched on, in order to avoid dischar-
ging the vehicles battery. Always disconnect the electricity if working on the electronics. The charger at the end of
the battery compartment automatically detects the voltage (12-24V Direct Current).
2 0
Warning! If the docking station
is directly connected to 12-24V=,
watch the polarity! Shorten the
cable to the length you need.
- +
Charging with power adapter or 12V cable
With the power adapter the Betty TL2 Pro can be charged from the wall socket.
1. Plug the supplied power adapter into your wall socket and connect it to the docking station.
2. Make sure the lock is open. Set and press the TL2 Pro into the docking station. You must overcome a
clear pressure point. A high resistance must also be overcome when the lamp is removed. Do not be
hesitant.
3. Charging starts automatically, the LEDs flash green. When the battery is full, the LEDs light green.
Charge via the internal charging socket
Alternatively, the Betty TL2 Pro can also be charged with many Lupine standard chargers.
1. Plug the charger into your wall outlet.
2. Unscrew the rechargeable battery from the flashlight and the
charging socket becomes visible.
3. Plug the charger into the battery compartment.
4. If the battery is charged via the charging socket, no LEDs illuminate
at the end of the battery compartment. The feature is only available
when using the docking station.
Alternative charging socket
for Charger One, Microcharger
and Wiesel.
21