j.e. StorkAir RPM Bedienungsanleitung Seite 31

Condenser block (pos. 8) (AC)
Dismantling:
Using a screwdriver, apply lateral pressure to a click
connector on one side of the condenser block and
simultaneously lift the block up. Remove it from the fan
unit and uncouple the connectors.
Assembly:
Connect the fan wiring to the condenser block.
(diagram fi g. 5)
Press the condenser block upright between the
projections on the fan unit. Then press it till the click
connectors are fastened.
Control print (pos. 4) for DC version
Remove the PCB cover (pos 3) prior to dismantling the
control print.
Dismantling:
Using a screwdriver, apply lateral pressure to a click
connector on one side of the control print and simul-
taneously lift the block up (pos. 8). Remove it from the
fan unit and uncouple the connectors.
Assembly:
Connect the fan wiring to the control print. Press the
control print upright between the projections on the fan
unit. Then press it till the click connectors are fastened.
Fan unit (pos. 9)
Dismantling:
Unscrew the four M5 bolts (pos.6).
Remove the fan unit from the casing.
. Attention! Ensure that the power cable is
given suffi cient room.
Assembly:
Place the fan unit back on the casing so that the
grooves in the bottom of the unit fi t around the edges
of the blades.
Re-tighten the four M5 bolts (pos. 6).
Ensure that the cable is not pinched between
the fan unit and the blade unit.
31