Operation; Maintenance - Makita CL070D Betriebsanleitung

Connect capsule. Align projection on capsule with
projection on handle and then firmly twist capsule in
direction of arrow until it is secured. (Fig. 12 & 13)
NOTE:
• Always remove dust ahead of time, as suction power
will be reduced if there is too much dust in cleaner.
• Always be sure to check that both filter and prefilter are
loaded correctly prior to using cleaner. If they are not
loaded correctly, dust will get into the motor housing,
and cause motor failure.
If the following examples occur, filter and prefilter are
not loaded correctly. Reload them correctly to rectify
problem.
Problem Examples
Example 1: Only prefilter has been loaded (no filter)
(Fig. 14)
Example 2: Only filter has been loaded (no prefilter)
(Fig. 15)
Example 3: Filter has been loaded in a peeled back state
(Fig. 16)
Example 4: Prefilter's securing lip is not firmly locked into
groove of cleaner housing (Fig. 17)

OPERATION

CAUTION:
• To connect attachments, such as nozzle, twist-insert
attachment in direction of arrow to ensure secure con-
nection during use. To disconnect attachment, twist-
extract also in direction of arrow.
If attachment is twisted in the opposite direction, when
being connected or disconnected, capsule may
become loose. (Fig. 18)
Cleaning (Suction)
Nozzle (Fig. 19)
Attach the nozzle to clean off tables, desks, furniture, etc.
Nozzle slips on easily.
Things to Check Before Asking for Repairs
Symptom
Weak suction power
Not working
NOTE:
• Do not attempt to repair cleaner by yourself.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using Makita replacement parts.
8
Area to be investigated
• Is capsule full of dust?
• Is filter clogged?
• Is battery exhausted?
• Is battery exhausted?
Nozzle + Extension wand (Straight pipe) (Fig. 20)
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for
cleaning a floor while standing erect.
Corner nozzle (Fig. 21)
Fit on the corner nozzle for cleaning corners and crevices
of a car or furniture.
Corner nozzle + Extension wand (Straight pipe)
(Fig. 22)
In tight quarters where the cleaner itself cannot squeeze
in, or in high places hard to reach, use this arrangement.
Cleaning without nozzle (Fig. 23)
You can pick up powder and dust without nozzle.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off before
attempting to perform inspection or maintenance.
After use (Fig. 24)
When storing the cleaner, hang it from a nail using the
convenient hanger in back.
Cleaning
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper pack
mounting area and the dust stopper. (Fig. 25)
CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Wash the filter in soapy water when it is clogged with
dust and the cleaner power becomes small. Dry it out
thoroughly before use. An insufficiently dried filter may
cause poor suction and shorten the service life of the
motor. (Fig. 26)
• Empty dust from capsule.
• Dust down or wash filter.
• Recharge battery.
• Recharge battery.
Fixing method