Overriding/Ignoring Ph Probe - Davey Lifeguard DPLGEU Installations- Und Betriebsanweisungen

• Press the
Figure 8.16
• Press the
menu/setting select button;
Figure 8.17
• Now follow the instructions for PH calibration from Section 6.5.
8.1.2.2. Using the app
Note: the pH cannot be calibrated via the app.

8.1.3. Overriding/ignoring pH probe

Should the need arise whereby the pH probe needs to be isolated (turned off, or ignored) this is possible
both via the Lifeguard control panel, or via the Davey Lifeguard app. This may become necessary if the
probe is damaged during a maintenance clean. If the probe is damaged, refer to maintenance Section 11.
8.1.3.1. On the Lifeguard control panel
• From the HOME SCREEN, press the
main menu (Figure 8.18);
Figure 8.18
• Press the
menu up/down button (Figure 8.16);
maintenance:
-> calibration
clean cell
replace cell
menu up/down buttons to scroll down to PH CAL (Figure 8.17). Then press the
calibration:
-> ph cal
orp cal
salt cal
menu/setting select button. This will now show the
main:
-> modes
settings
maintenance
menu up/down, scrolling down to settings (Figure 8.19);
34
▲ CONTENTS