Stiga CP1 430 Li 48 serie Gebrauchsanweisung Seite 77

9. The battery charger is
not charging the battery.
12.2 FOR MACHINES WITHOUT ELECTRONIC
CONTROL
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The engine does not start
when using the switch
2. The engine stops and the
machine emits an acous-
tic signal.
3. Mowing is difficult.
4. Excessive noise and/or
vibration is experienced
whilst working.
Battery is not correctly inserted in the
battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly.
Safety key in "OFF" position.
Battery is not inserted or is inserted
incorrectly.
Low battery.
Incorrect battery combination.
Battery is not inserted correctly.
Low battery.
The thermal protection has tripped due
to overheating of the motor.
Cutting means blocked.
Machine fault
The cutting means is not in good state.
Cutting means fittings are loose or the
cutting means is damaged.
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with suitable
temperatures (see battery/battery charger in-
struction manual).
Clean the contacts.
Check it is plugged in and the power socket is
energised.
Replace with an original spare part.
If the problem persists, refer to the battery/
battery charger manual.
Insert the key (par. 6.3).
Turn the safety key to "ON" position (par. 6.3).
Open the hatch and check that the battery is
fitted in its housing correctly (par. 7.2.3).
Check the battery status and recharge if nec-
essary (par. 7.2.2).
Check if the battery combination is correct,
following the instructions supplied in the "Tech-
nical data" table.
Open the hatch and check that the battery is
fitted in its housing correctly (par. 7.2.3).
Check the battery status and recharge if nec-
essary (par. 7.2.2).
Wait for at least 5 minutes and restart the
machine.
Turn the machine off, remove the safety key
and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that pre-
vent rotation of the cutting means.
If the problem continues, contact the Author-
ised Service Centre for checks, replacements
or repairs (par. 8.1).
Remove the safety key and contact the Author-
ised Service Centre for checks, replacements
or repairs.
Contact the Authorised Service Centre for
the sharpening or replacement of the cutting
means.
Immediately turn off the motor and remove the
safety key.
Contact the Authorised Service Centre for
checks, replacements or repairs (par. 8.1).
EN - 11
SOLUTION