Safety Instructions For Maintenance; Possible Malfunctions - Bartscher MINI II Bedienungsanleitung

6.3 Safety instructions for maintenance

o Inspect the power cable regularly for damage. Never use the device if the cable is
damaged. If the power cable is damaged, have an authorised service center or
qualified electrician replace it.
o In case of damage or malfunction, please contact your stockist or our customer
service centre. Pay attention to the troubleshooting tips in pt. 7.
o Only a qualified technician and using original spare parts and accessories should
carry out repairs and maintenance of the device. Do not attempt to repair the
device yourself.

7. Possible Malfunctions

Problem
Device connected to
power source, red
standby light does not
come on, and the device
does not heat up.
Green control light
comes on but tempera-
ture does not rise
althought the tempe-
rature is set.
Heating element does
not heat after a short
time.
The above problems only serve for orientation and as examples. Should these or
similar problems occur, turn the device off immediately and discontinue using it.
Contact qualified technicians or the manufacturer for inspection and repair.
Cause
• Plug improperly inserted
into socket
• Safety fuse disconnected
• Fuse box improperly
mounted
• Micro fuse contact
malfunction
• Damaged temperature
controller
• No contact with the heater
• Damaged heater
• Safety thermostat
activated
Solution
• Remove plug and insert
properly into socket
• Check fuse, connect
device to another socket
• Check that fuse box is
properly mounted
• Contact a sales agent
• Contact a sales agent
• Press RESET button on
the back of the device
(see page 29)
- 31 -