Before Use; Operation - cecotec READY WARM 10100 SMART CERAMIC Bedienungsanleitung

3. BEFORE USE

1. Take the product out of the box and remove any packaging materials.
2. Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
3. Place the heater on a flat and stable surface.

4.OPERATION

1. Turn the power switch on. The appliance's default temperature is 25 ºC.
2. The display will show
CONTROL PANEL AND REMOTE CONTROL
a) Power levels
Press once to activate low-power heating mode.
Press twice to activate maximum-power heating mode.
b) Timer
Pulse repeatedly to select the desired time at which the appliance will switch automatically
off. It can be programmed from 1 to 8 hours, in 1-hour intervals.
c) Oscillation
Press to activate and to deactivate the oscillation mode..
d)Press the and
Note: all symbols on the display will turn off automatically after 10 minutes operation.
NOTE:
• The temperature can be set from 0 to 49 ºC.
• The appliance will automatically switch to maximum-power heating when the room
while in standby mode. Press to
buttons to increase or decrease the set temperature.
enter the control panel.
READY WARM 10100 SMART CERAMIC
ENGLISH
13