When To Change The Thread Lifters; How To Replace The Thread Lifters; Cleaning The Roller On The Allteq Floorhead; Cleaning And Care - Miele Blizzard CX1 Gebrauchsanweisung

 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one,
making sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a muni-
cipal recycling facility.

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 33)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 34)
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Always disconnect the vacuum
cleaner from the power supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and plastic ac-
cessories can be cleaned using a
standard domestic cleaning agent suit-
able for plastic.
Follow the special cleaning instruc-
tions for the dust container and filter
frame in "Maintenance" and for the
fine dust filter, the pre-filter and the
fine dust container in "Fault resolu-
tion".

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!

Do not let the vacuum cleaner
get wet! If moisture gets into the ap-
pliance, there is a risk of electric
shock.
en
41