Replacing One Type Of Exhaust Filter With Another; When To Change The Thread Lifters; How To Replace The Thread Lifters - Miele COMPACT C2 Gebrauchsanweisung

en
^ Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
^ Press the exhaust filter change
indicator ~ (dia. 13).
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the display (dia. 14).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
^ Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
10):
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
When changing the filter please note:
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that you
remove the filter grille before fitting the
new type of filter (dia. 36).
You will also need to press the exhaust
filter change indicator (dia. 13).
2. If you wish to replace exhaust filter b
or c with filter a, it is essential that you
also fit the filter grille * (dia. 34).
* Filter grille - see "Optional
accessories".
Do not use more than one exhaust
filter at a time.
40

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.
How to replace the thread lifters (dia.
37 + 38)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Upholstery nozzle SPD 10
(depending on model) (dia. 39)
a Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
b Fit a new thread lifter unit and lock
into position.
How to clean the roller on floorhead
SBD 285 AllTeQ (dia. 40)
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove.
c Remove the roller.
^ Remove any threads and hair,
replace the roller and refit the
bearing, locking it back into position.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).