Miele Blizzard CX1 Gebrauchsanweisung Seite 38

en
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power se-
lectors.
– Rotary selector
– Radio-control handle
Rotary selector (dia. 15)
 Turn the rotary selector to the suction
power setting you require.
Radio-control handle (dia. 16)
When the vacuum cleaner is switched
on with the On/Off foot control , the
suction power setting  will flash in
the vacuum cleaner display.
 Press the Standby button  on the
handle.
The suction power setting  will light
up in the vacuum cleaner display.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that, the vacuum cleaner will
switch on at the setting which was used
previously. This will flash.
 Press the + button on the handle to
select a higher suction power setting.
 Press the - button on the handle to
select a lower suction power setting.
To open the air inlet valve (dia. 17)
(not on models with radio-controls on
the handle or on Eco Comfort handles)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the va-
cuum cleaner.
38
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to man-
oeuvre.
During vacuuming
 When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.

When vacuuming, in particular
fine dust, e.g. sawdust, sand, plaster,
flour, talcum powder etc., electro-
static charges build up naturally. Un-
der certain conditions these charges
will be released. To avoid the un-
pleasant effects of these discharges,
a metal inlay has been incorporated
into the underside of the handle.
Please make sure that you keep your
hand in constant contact with this
metal strip during vacuuming. If your
vacuum cleaner is fitted with an Eco
Comfort handle, make sure you hold
it by the bowed section as this is
where this metal strip is incorporated
(dia. 18, 19 + 20).
If a large amount of dust has been va-
cuumed at once, the ComfortClean
self-cleaning function should be started
manually either during a vacuuming
pause or straight away. This enables
the vacuum cleaner to achieve the very
best cleaning performance again
straight away (see "Maintenance -
Starting the ComfortClean self-cleaning
function manually").