After Washing - Haier HW80-B14876N Bedienungsanleitung

6-Daily use
6-10
Start/Pause
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". Press it again to resume
operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2.
button gently to switch on.
3. Run programme "Spin/drain" to drain the water.
4. Select a new programme and start it.
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;

6.12 After washing

1. At programme cycle end
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display switch-
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the Spin /Drain programme.
3. Press the "i-time "button and "Speed" button at the same time for about 3 seconds.
"bEEP OFF" will be displayed and the buzzer will be deactivated. For activating the buzzer
press these two buttons at the same time again. "bEEP On" will be displayed.
18
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-10) to start; appli-
ance operates according to present settings. Changes
are only possible by cancelling the programme.
is displayed.
Loc1-
is displayed.
EnD
EN
Press this