After Washing - Haier HW80-B1439N Bedienungsanleitung

EN
 6WDUW ZDVK SURJUDPPH
Press "Start/Pause" button (Fig. 6-8) to start. The
/(' RI WKH 6WDUW3DXVH EXWWRQ VWRSV DVKLQJ DQG
lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the pro-
gramme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
LV DVKLQJ 3UHVV LW DJDLQ WR UHVXPH RSHUDWLRQ
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2. 3UHVV 2Q2
Press "On/Off" button to turn on the appliance,select programme Spin and then se-
3.
lect "no Speed"(speed lights are off) ,start the machine to drain the water.
4. After closing the program to restart the appliance,select a new programme and start it.
Note: Door lock
▶ For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
▶ In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; /RF
3.

6.12 After washing

1. At programme cycle end (1' is displayed.
2. 7KH DSSOLDQFH VZLWFKHV R DXWRPDWLFDOO\
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. 7XUQ R WKH ZDWHU VXSSO\
5. 8QSOXJ WKH SRZHU FRUG
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
1RWH 6WDQGE\ PRGH  HQHUJ\VDYLQJ PRGH
The switched on appliance will go into standby mode if it will not be activated within 2
minutes before starting the program or at the end of program. The display switches
R  7KLV VDYHV HQHUJ\ 7R LQWHUUXSW WKH VWDQGE\ PRGH SXVK 6WDUW3DXVH EXWWRQ
 $FWLYDWH RU GHDFWLYDWH WKH EX]]HU
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the SPIN programme.
3. Press the "Steam" button and "Extra rinse" button at the same time for about 3
seconds. "E((3 2))" will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. "E((3
be displayed.
EXWWRQ IRU DERXW  VHFRQGV WR VZLWFK WKH DSSOLDQFH R 
is displayed

6-Daily use
6-8
" will
ON
17