After Washing; Standby Mode - Haier HW80-B14266A-EC Bedienungsanleitung

16
Function
Selection Delay
Environmentally responsible use
To T T achieve best use of energy, y y water
recommended maximum load size
Do not overload (hand width clearance above laundry).
Apply exact dosages of each washing agent.
Choose the lowest adequate washing temperature - modern detergents are
efficiently cleaning below 60°C
Raise default settings only due to heavy staining.
Select max. spinning speed if a domestic dr .
Interrupt - cancel wash programme
To T T interrupt a t running prog
Pause".
Programme run-time is flashing. Pr
operation.
To T T cancel a running programme and all its individual set-
tings activate "Start/Pause" and then fo f f r about 3 seconds
"On/Off f f " f f .

After washing

At programme cycle end
machine will shut off automatically. y y
Remove laundry as soon as possible to go easy on it and
to prevent more wrinkling.
T T Turn off the water supply and unplug the pow
Open the door to prevent formation of moisture and
odours. Let it open while not used. .
Standby-mode b b
The switched on washing machine will go into standby-
mode if it will not be activated within 2 minutes before
starting the program or at the end of program.To T T inter- r r
rupt the standby-mode push one ke k k y. y y During standby-
mode the Start/Pause button shine all the time.
Activate or deactivate the buzzer
1. Switch on the appliance.
2. Select the "Spin/drain" programme.
3. Press the "function" and "selection" button (also as
"speed up") at the same timefor 3 seconds. "BEEP
OFF" will be dis
For activating the buzzer please press these two buttons
at the same time again. "BEEP ON" will be display a a ed.
, , r r detergent and time you should use the
q q
.
a a
r r ramme press gently "Start/
. ess it again to resume
End" is display a a ed, afterwar
"
.
play a a ed and the buzzer will be deactivated.
yer is used.
Daily use a a
, ds
er cord.
-