Information Codes; 9-Troubleshooting - Haier HW80-B14876N Bedienungsanleitung

EN
of a problem please check all shown possibilities and follow below instructions before you
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service

9.1 Information codes

Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
The remaining wash cycle time will be 1 hour and 25 minutes.
1:25
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 minutes.
6:30
Automatic load detection is working; only in some programs.
AUTO
End
Loc 1- Door is closed because of high water level, high water temperature or spinning cycle.
The buzzer is deactivated.
bEEP OFF
The buzzer is activated.
bEEP On
The function keys is closed. The programme changing is invalid.
cLo 1-
9.2 Troubleshooting with display code
Problem Cause
• Drainage error.
CLR FLTR
E2 • Lock error.
• Water level not reached after 12 minutes.
E4
• Drain hose is self-syphoning.
E8 • Water protective level error.

9-Troubleshooting

Solution
•
• Check drain hose installation.
• Shut the door properly.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales service.
23