Dometic CFF20 Bedienungsanleitung Seite 22

Operation
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate. We recommend keeping a gap of at least 50 mm around ventilation
holes.
A
NOTICE! DAMAGE HAZARD
Place the cooler as shown (fig. 1, page 3). If you operate the cooler in
a different orientation it can be damaged.
➤ Connect the cooler (see chapter "Connecting the cooler" on page 19).
A
NOTICE! EXCESSIVELY LOW TEMPERATURE HAZARD
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Press the "ON/OFF" button (fig. 3 1, page 5) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 2, page 5).
✔ The display (fig. 3 4, page 5) switches on and shows the current temperature.
✔ The cooler starts cooling the interior.
I
NOTE
When operating from a battery, the display switches off automatically if
the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2, page 4) down, until it latches in place audibly.
I
NOTE
CFF35, CFF45: When latching the lid, ensure that both latch side pins
are fully engaged to ensure a good lid seal. One latch may engage
slightly before the other.
If the lid is not closed equally at both sides, press until a second click is
heard.
22
CFF20, CFF35, CFF45, CFF70DZ
EN