Before Using The Appliance; Basic Operation - Bosch MUZS24DSW Gebrauchsanleitung

4.4 Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
If the continuous feed shredder is
overloaded or blocked, the disc
holder shaft will break at the prede-
termined breaking point.
Note: Spare parts with a predeter-
mined breaking point are not covered
by our warranty obligations. A new
disc holder is available from cus-
tomer service under order number
00630760.

Before using the appliance

5 Before using the appli-
ance
Prepare the base unit and the ac-
Before using the appliance
cessories for use.
5.1 Overview of base units
You can prepare your kitchen ma-
chine as shown.
→ Fig.
3
Food processor from the
A
MUM5 series
Food processor from the
B
MUMS2 series
5.2 Assembling the continu-
ous feed shredder
Grip the disc holder level with the
1.
wings.
→ Fig.
4
The two plastic tips must point up.
Before using the appliance en
Take hold of the required cutting
2.
disc by the edge and fit onto the
disc holder with the side you re-
quire facing up.
Fit single-sided discs with the
‒
blades or serrations facing up.
Fit reversible discs with the re-
‒
quired marking facing up.
→ Fig.
5
Insert the disc holder with the cut-
3.
ting disc into the housing.
→ Fig.
6
Place the lid on the housing.
4.
→ Fig.
7
Markings and
up.
Rotate the lid clockwise until it en-
5.
gages.
→ Fig.
8
Markings and
up.
5.3 Fitting continuous feed
shredder onto the base
unit
Place the continuous feed shred-
1.
der on drive 2 as shown.
→ Fig.
9
Push the continuous feed shredder
2.
down and rotate clockwise until it
engages.
→ Fig.
10
The continuous feed shredder
must be securely connected to the
base unit.

Basic operation

6 Basic operation
Basic operation
6.1 Processing food with the
continuous feed shredder
Note: Take note of the recommended
speeds.
→ "Application examples", Page 21
must match
must match
19