Installation - Hama EWS-3200 Bedienungsanleitung

• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Do not mix old and new batteries or batteries of a
different type or make.
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.
4. Getting Started
Note
Always make sure to start the measuring station first and
then the base station.
4.1. Measuring station
• Open the battery compartment (43), remove the contact
breaker and then close the battery compartment (43).
• Press the CH button (40) repeatedly to select the channel
the measuring station is to use for transmission. CH1, CH2
or CH3 is shown on the display.
• Press the °C/°F button (42) to choose between °C and °F
for the temperature display.
• Then close the battery compartment cover.
All manuals and user guides at all-guides.com
4.2. Base station
• Open the battery compartment (36) and insert three
4.3. Replacing the batteries
Measuring station
• When the
• Open the battery compartment (43), remove and properly
Base station
• When the
• Open the battery compartment (36), remove and properly

5. Installation

AA batteries with the correct polarity into the battery
compartment (36). Then close the battery compartment
cover.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring
or base station.
• To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
symbol (26) appears, replace the 2 AAA
batteries for the measuring station with 2 new ones.
dispose of the depleted batteries, and insert two new AAA
batteries with the correct polarity. Then close the battery
compartment cover.
symbol (22) appears, replace the 3 AA
batteries for the base station with 3 new ones.
dispose of the dead batteries and insert two new AA
batteries with the correct polarity. Then close the battery
compartment cover (36).
Note – Installation
• We recommend initially placing the base and
measuring stations in the intended locations without
installing them and making all the settings described in
6. Operation – to do.
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.
3