Checking The Charge Status Of The Rechargeable Battery; Used Batteries; Working With The Appliance; Charger - FLORABEST FRMA 36/2 A1 Originalbetriebsanleitung

Allow a freshly charged battery (9)
to cool down for approx. 15 min-
utes before inserting it into the bat-
tery charger (19).
1. Remove the battery (9) from the
appliance.
2. Slide the rechargeable battery
(9) onto the charger (19). It locks
into place audibly.
3. Plug the charger (19) into an
electrical outlet.
4. After the charging process, dis-
connect the charger (19) from
the mains supply.
5. Press the release buttons (9a) on
the battery (9) and pull the bat-
tery (9) out of the charger (19).
LED control indicators:
• The red LED indicator (19a) of the

charger (19)

- displays a steady red light when the
charger is connected to the mains
supply. It goes off when a battery is
inserted.
- flashes in the case of complications
(e.g. battery too hot).
• The green LED indicator (19b) of the
charger (19)
- flashes during charging.
- displays a steady green light when
the battery is being charged.
Checking the charge status
of the rechargeable battery
You can check the charge status:
directly on the battery (9)
or
• Press the button
The number of illuminated LEDs shows
the charge status of the battery (
All LEDs are lit: battery is fully charged.
1 LED is lit: battery is empty, please
charge.

Used batteries

• If a fully recharged battery lasts for con-
siderably shorter operating times, the
battery ( 9) is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Working with the appliance

Observe the noise protection and
local regulations.
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
GB
on the release button
( 16).
9):
59