GBC eWire Bedienungsanleitung Seite 17

Double Loop
A double loop occurs when a row of wire other than the one being fed
has slack in it. This will result in a J320 wire jam code.
To resolve this, follow the slack wire to the top of the spool and gently
pull the slack clockwise. This will transfer the slack to the next row of
wire, repeat this until the all the slack is in the last row being fed.
C. Troubleshooting
This section will lay out the troubleshooting steps for when sheets are
not being hooked on the twin loop wire tips. In some cases, it will also
create a Jam code. J244 (Sheets left in stack area) is the most likely
Jam to be caused as a result of poor hooking. Before changing any
settings on the eWire™ or the AdvancedPunch Pro, review each
trouble shooting step below.

Verify that the eWire™ is properly docked to the upstream
device and confirm that there is no misalignment between
the devices.

Check that printed sheets do not have excess curl. When
laid on a flat surface, no edge of the paper should be higher
than 3/8in (10mm). Review the printer manual to resolve this
if present.

Inspect the element spool for damage, if the wire is damaged
removed the damaged length of wire or replace the spool
with one of the same size. See Section 9 C Common Spool
Issues for details.

Verify the proper element size is being used for the amount
of sheets in the book being run. Refer to the chart in Section
10

Examine your unhooked sheet for damage around the holes,
this can manifest as tears or imprints. If any is present,
proceed to the Deflector and Alignment Adjustment
D. Punch Hole Quality:
If the punch upstream of the eWire™ is not punching holes within
specification, the binding capabilities of the eWire™ will be reduced,
resulting in jams and unhooked sheets.
1. Using the Hole Position Tool provided, confirm the backgage depth
and alignment of a single punched sheet. To use the tool, take a
punched, unbound sheet of paper and align it with the either the
"LTR" or "A4" corner, depending on the paper size. The black lines
should faintly visible behind the sheet, when the punch is properly
aligned, the black circles will be evenly visible around all of the
punch holes.
2. If the holes do not align with the outlines on the tool, refer to the
AdvancedPunch Pro user manual to make adjustments to the hole
position.
12
eWire™
ro
GB