Herunterladen Inhalt Inhalt Diese Seite drucken

Use And Operation - Klarstein 10029393 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für 10029393:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Installation
• Take out the unit after opening the carton box, and check whether
there's a remote controller, two ice boxes and four castors.
• Install the castors before operating the unit. The unit should be placed
horizontally during installation. Fix the steel shaft of castor at the castor
installation hole at the bottom of unit and then knob the castor into the
installation hole carefully.
• The unit should be placed horizontally. Please don't tilt the unit and
check whether the socket power comply with the parameter on the
nameplate when operating the unit.
Fill water
• Draw out the water tank.
• Charge clear tap water for new units or units that haven't been used for a long time. Please unplug the power
plug before filling water to avoid damage to the electric parts.
• Charge water within the Max. mark, otherwise water will overflow from the unit.
Remote Controller Operation
The functions of some buttons on the remote controller are the same as those on the control panel. Point the
infrared transmitting tube at the body when operating it. There should be no obstruction between the remote
controller and the body.
Storage:
When the unit won't be used for a long time, clean out the water inside the water tank and then let the fan run
at normal temperature for some time. After the evaporator in the unit is dried completely, cover the unit with
plastic bag and then put it into the carton box.
Cleaning
After this unit has been used for a long time, the water tank, the evaporator and the filter of evaporator will
be blocked by dust and sundries, which will affect the air volume and cooling effect. lt is recommended to
clean the water tank, the evaporator and the filter once every two weeks.Note: Unplug the power plug before
cleaning.
When operating the unit, the evaporator must be placed at the appointed position in the unit, otherwise it
will affect the unifs normal operation and service life, even bum out the motor. Befora moving the unit, ple-
ase check whether there's water in water tank. If there's water, please drain it out. If you need to take out the
evaporator, please make sure the unit is turned off. Otherwise, it may lead to water leakage or water spout out.
11

Use and Operation

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

10029394

Inhaltsverzeichnis