Use And Operation - Klarstein 10029702 Anleitung

1. After putting through the power, press „ON/OFF" button on remote controller to turn on the air conditioner.
2. Press „MODE" button to select your required mode: COOL, DRY, FAN.
3. Press „+" or „-" button to set your required temperature. (Temperature can't be adjusted under auto mode).
4. Press „FAN" button to set your required fan speed: auto, low, medium and high speed.
replacement of Batteries
Press the back side of remote controller on the spot and then push out the cover of battery box along the arrow
direction. Replace two No.7 (AAA 1.5V) dry batteries and make sure the positions of + and - polar are correct.
Reinstall the cover of battery box.
Hints on Using the Remote
• During operation, point the remote control signal sender at the receiving window on unit.
• The distance between signal sender and receiving window should be no more than 8m, and there should be
no obstacles between them.
• Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote
controller should be close to the unit during operation.
• Replace new batteries of the same model when replacement is required.
• When you don't use remote controller for a long time, please take out the batteries.
• If the display on remote controller is fuzzy or there' s no display, please replace batteries.
Manual Removement of collected Water
When using the continuous drainage option from the bottom hole, install drainage pipe before using, otherwi-
se poor drainage will affect normal operation of the unit.
Remove the rubber plug at drainage port. Fix the drainage pipe clip on the right of rear side plate near drainage
port with a screw.

Use and Operation

22