Beep - Atag IG9071MX Anleitung

USE INDUCTION COOKING ZONES
In the event of overheating the result will be that the cooking zone in
question or all the cooking zones will display one of the following
reactions:
– the hob will reduce the power supplied slightly (this is not visible in
the cooking settings in the displays);
– If this does not help, the hob will switch one or more zones off and
indicate 'F8' in the display. The text will remain until you press the
on/off button of the zone with the error indication once.
As soon as the cooking zone(s) has/have cooled down sufficiently, they
can be operated normally once again. F8 remains visible on the display
until you operate the on/off switch with the error message.
Prevent the overheating protection becoming activated by:
– using pans that are good conductors of heat;
– heating up fat or oil at a lower setting;
– making sure there is sufficient ventilation.
If, despite the above-mentioned measures having been taken, the
overheating protection becomes activated again, contact the service
department or a professionally qualified specialist.
158
extra safety USE INDUCTION COOKING ZONES
Switching the beep off/on
The beep, which can be heard when the buttons are pressed, can be
switched off or on.
switching the beep off
1. Switch the front-left cooking zone on and then off by pressing the
on/off button twice.
2. Press simultaneously, within 3 seconds, the – button of the front left
cooking zone and the – button of the rear left zone. A beep confirms
the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now switched
off. Repeat this operation for the right-hand cooking zones using the
on/off button from the rear right cooking zone and the – button for the
front-right cooking zone.
switching the beep on
1. Switch the front-left cooking zone on and then off by pressing the
on/off button twice.
2. Press simultaneously, within 3 seconds, the – button of the front left
cooking zone and the – button of the rear left zone.
A beep confirms the setting that has just been selected.
Repeat this operation for the right-hand cooking zones using the on/off
button from the rear right cooking zone and the – button for the front-
right cooking zone.

beep

159