Atag HL70..Q Bedienungsanleitung Seite 30

operation
switching on
switching off
Press the on/off switch.
The cooking zone switches off.
The residual-heat indicator will continue to indicate that the
on/off switch zone is hot if it still is.
residual-heat indicator
The indicator shows that the cooking zone is still hot, and
goes out as soon as the glass top reaches a safe
temperature.
Residual heat is shown in the display with an H.
residual-heat indicator
fast-cook setting
You will normally bring food to the boil on a high setting and
then switch to a lower setting to allow it to cook through.
The fast-cook setting can do this for you. The fast-cook
setting automatically switches the hob down to the setting
fast-cook setting selected for cooking through.
switched on
After a while, you will notice that you always let potatoes, for
example, cook through on the same setting - setting 4, for
example. In that case, select fast-cook setting A4 and the
appliance automatically switches down to setting 4 as soon
as the food boils.
The fast-cook setting can be used in combination with the
timer. Take care, however, that you increase the cooking time
by the fast-cook time (see also the "timer" section on page 9).
attention
A condition for using this setting is that you use a good
quality pan with a heavy base.
When cooking small quantities, the fast-cook setting may be
too fierce. In that case, do not use the fast-cook setting.
GB 8
switching on fast-cook setting
1 Put a pan on the cooking zone
2 Press the on/off button.
A horizontal line (–) appears in the display.
on/off switch 3 Press the + button.
12 appears in the display.
4 Press the + button again.
A1 appears in the display. If the button is pressed again,
+ button the next setting appears. You can choose from 9 settings
(see table).
As long as there is the letter A in the display – A3, for
example – a high power level is being used for fast
cooking.
If there is only a number – 3, for example – the cook-
fast-cook setting
switched on through setting has been switched on.
In the table below, you can see the fast-cook times for the
various fast-cook settings. The number after the A indicates
the setting used for cooking through. On fast-cook setting A6,
for example, the food is fast-cooked at a high power level for
the first ten minutes and then cooked through on setting 6.
setting fast-cook time
A1 1,5 minutes
A2 2 minutes
A3 3 minutes
A4 4 minutes
A5 6 minutes
A6 10 minutes
A7 13 minutes
Three seconds after being switched on, the automatic cooking
device can be switched off again using the + or – button.
timer
The timer only gives a signal at the end of the time set.
1 Press the timer button.
A zero will appear in the display.
timer button
operation
switching on
setting searing time
A8 2 minutes
A9 2,5 minutes
GB 9