Specifications - Makita DFL300FZ Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Battery cartridge
1-2. Red part
1-3. Button
2-1. Switch trigger
3-1. Reversing switch lever
4-1. Lamp

SPECIFICATIONS

Fastening torque
BL1430 / BL1440
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
For Model DFL300F
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-2. LED indicator
5-1. Screw
6-1. Angle head
6-2. Ring
6-3. Scale
6-4. Compression spring
Model
Hard joint
With battery
BH1427
Soft joint
Hard joint
With battery
Soft joint
Square drive
-1
)
Dimensions
Net weight
Rated voltage
) : 72 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
DFL300F
16 - 30 N • m
16 - 30 N • m
16 - 30 N • m
16 - 27 N • m
9.5 mm
506 mm x 73 mm x 104 mm
1.9 kg
ENE033-1
For Model DFL400F, DFL401F
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
ENG104-1
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration
determined according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
ENG204-2
Uncertainty (K) : 1.5 m/s
sum) The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
6-5. Yellow line
6-6. Hole for adjusting grip
6-7. Adjusting grip
8-1. Socket
8-2. Hole
8-3. Pin
400
510 mm x 73 mm x 104 mm
D.C. 14.4 V
) : 73 dB (A)
pA
Wear ear protection
total value (tri-axial
) : 2.5 m/s
h
2
DFL400F/DFL401F
25 - 40 N • m
25 - 40 N • m
25 - 40 N • m
25 - 38 N • m
9.5 mm
260
2.0 kg
ENG104-1
ENG204-2
vector sum)
2
or less
ENG901-1