Automatic Heat Up; Power Function - AEG HC452401EB Benutzerinformation

10 www.aeg.com

4.6 Automatic Heat Up

Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
Immediately touch a desired heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.

4.7 Power function

This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to "Technical
information" chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
4.8 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function.The selection of the Timer
function is possible for cooking zones
that are active and after the heat setting
is set.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on. When
this function is active,
( comes on).
comes on.
. comes on.
comes on.
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
cooking zone starts to flash slowly the
time counts down.
To see the remaining time: set the
cooking zone with
the cooking zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the cooking
zone with . Touch
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking
zone deactivates.
To stop the sound: touch
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the cooking zone operates.
To set the cooking zone (if more than
1 cooking zone operates): touch
again and again until the indicator of a
necessary cooking zone comes on. When
this function is active,
To activate the function: touch
symbol goes out and
To see how long the cooking zone
operates: set the cooking zone with
The indicator of the cooking zone starts
to flash quickly. The display shows how
long the zone operates. During the first
minute the display shows the time in
seconds. After the first minute the
display shows the time in minutes.
To deactivate the function: set the
cooking zone with
. The symbol goes out and
comes on.
of
. The indicator of
or .
and touch . The
.
comes on.
. The
comes on.
.
and touch or