What To Do If - Zanussi zcg55dg Benutzerinformation

3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat.
3
2
2
5
Use a spatula made of
wood or plastic or equiva-
lent to open the inner
door.
Hold the outer door, and
push the inner door
against the top edge of the
door.

What to do if...

Problem
The flame is blown out immediately
after ignition.
The gas ring burns unevenly.
The oven does not heat up.
1
1
4
Place the door on a
stable surface protected by
a soft cloth.
Use a screwdriver to re-
move 2 screws from the
bottom edge of the door.
Important! Do not lose the
screws.
.
6
Lift the inner door.
7
Clean inner side of the
door.
Clean the glass panel with
water and soap. Dry it
carefully.
Possible cause
The thermocouple is not heated suffi-
ciently.
The burner crown is blocked with
food residue.
The oven is not activated.
Warning! Only clean the glass panel with water and
a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause
damage to the glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in opposite way.
4
4
6
5
5
After lightning the flame, keep the
knob pushed for approximately 5
seconds.
Make sure that the injector is not
blocked and the burner crown is clear
of food particles.
Activate the appliance.
Remedy
29